SA Standard Number Plate Brackets

4 products
Sort by
 

The Guide

SA Standard Number Plate Brackets & Mounting

Issued is 372 x 134mm. Personalised is 371 x 133mm. South Australia's government-issued plate runs to the regular Australian passenger size — 372mm wide by 134mm high. EzyPlates personalised standard plates are listed a millimetre smaller in both directions at 371 x 133mm. On a mount cut to tight tolerance, that's worth knowing before you order.

Measure the plate, not the paperwork. Nothing on your rego documents tells you which of the two you're holding. Take a tape to the plate itself, horizontally and vertically, and order to the measurement.

You might only need one standard bracket. EzyPlates sells slim front with standard rear as a pairing, so plenty of South Australian cars carry a standard plate on the back and a slim one on the front. If that's your setup, order one standard mount here and one slim mount from the slimline range — not two of the same.

Aluminium, not plastic. Every FLX mount is CNC-lasered from high-grade aluminium and anodised black, holding the plate flat and square where a factory plastic surround flexes, fades and sits proud of the panel. It fits your car's existing factory mounting points — nothing drilled into the plate, nothing drilled into the bumper — with black stainless hardware included.

SUPPORT

Frequently Asked Questions

Find answers to common questions about FLX brackets and kits.

FLX — Precision Built. Melbourne Made.
Government-issued standard plates are 372mm wide by 134mm high. EzyPlates personalised standard plates are listed at 371 x 133mm — a millimetre smaller in both directions. Measure yours before ordering.
Not quite. There's a millimetre difference in both width and height, and nothing on your registration paperwork will tell you which you have. The plate itself is the only reliable source.
Depends on your plate pairing. If you run standard front and rear, you need two standard mounts. But EzyPlates also sells slim front with standard rear, and if that's your setup you need one standard mount and one slim mount from the slimline range.
No. A slim SA plate is 371 x 100mm against a standard at 371–372 x 133–134mm. The height difference is over 30mm, so each needs a mount cut to its own dimensions.
No. FLX mounts use your vehicle's existing factory mounting points and the holes already in the plate from manufacture. Nothing gets drilled, which keeps the panel clean and your resale value intact.
30-day return policy on all products. If it isn't right, contact the team and we'll sort a return or exchange.